Requirements
The following requirements are listed for using WORK & MOVE Coach.
Operating systems
The following operating systems are supported, including 32- and 64-bit versions:
Windows 10 and Windows 11
Windows Server 2016 and higher
WebView2 (optional)
Some features in WORK & MOVE Coach rely on WebView2, but it isn’t required to run the application. However, when you use a feature in WORK & MOVE Coach that depends on WebView2, you may be prompted to install it.
LINAK powered sit-stand desk
The sit-stand desk needs to be equipped with a supported LINAK control box. WORK & MOVE Coach supports:
Control Box CBD 4 with S.W. P/N number 77432 and higher (cable type 1)
Control Box CBD 5 (cable type 1)
Control Box CBD 6 (cable type 1 or cable type 2)
The number of the LINAK Control Box can be found on the sticker. See the example below where the number is marked with a red outline.

You also need a USB cable to connect your control box. WORK & MOVE Coach supports the following cable types. Please check if the cable type is compatible with the control box:
The LINAK USB2LIN Version 1.63 or higher.
The orange WORK & MOVE desk connector cable with firmware version 1.71 or higher.
LOGICDATA powered sit-stand desk
The sit-stand desk needs to be equipped with a supported LOGIClink controller. WORK & MOVE Coach has experimental support for:
LOGICDATA LOGIClink Personal Lite connected with a USB cable.
LOGICDATA LOGIClink Personal Standard connected with a USB cable.
LOGICDATA LOGIClink Corporate connected with a USB cable.
Please note the experimental LOGIClink support needs to be enabled in the desk settings screen. Please contact your LOGICDATA supplier to check if your control box and handset are compatible with LOGIClink.
Last updated